38
Wireless LAN Interface
When using the wireless LAN interface, it is recommended to connect the printer to a host PC
via the USB cable first and use EpsonNet Config to set wireless LAN settings.
When you set up the access point at the same time, set the access point in advance and
check that it operates correctly.
Examine the radio wave situation in the surrounding area before use.
Avoid using the same channel that is used in the neighboring shops where wireless LAN is used.
When using the printer in environments where kitchen microwaves and other devices
that may interfere radio waves are installed, observe the following points.
Keep the printer away from the devices, such as kitchen microwaves, that may cause
radio wave interference.
Use channels that are away from the frequency bands that may cause radio wave interference.
Place shields between the printer and the devices that may cause radio wave interference.
Select either 2.4 GHz or 5 GHz, whichever is free from radio wave interference.
In auto channel setting for the access point, do not select a channel in which the
devices may cause radio wave interference.
In the infrastructure mode, W53 and W56 channels are not available to connect to a
stealth SSID access point.
To Next Page
Loading...
