Chapter 2 Setup
41
2
6
Configure the [Network] settings and the [TCP/IP] settings.
7
Disconnect the USB cable, turn off the printer, and then turn it back on.
Confirming the operation
Confirm that the printer is connecting to the network. There are the following methods:
•Confirm using a web browser
•Confirm using EpsonNet Config
•Confirm using the PING command from the command prompt
This section describes how to confirm using a web browser.
1
Confirm that the network is running; then start up the computer of the
network.
2
Start up the web browser and input the printer’s IP address in the address
bar.
http://(printer’s IP address)/
3
The “EpsonNet Config” window is displayed.
If the “EpsonNet Config” window is not displayed, connect the computer for setting to the
printer with the USB cable, then confirm the setting again.
To start wireless LAN communication, be sure to disconnect the USB cable, turn off the
printer, and then turn it back on.
If you need to configure other settings, use EpsonNet Config (web version). For information
about EpsonNet Config (web version), see "Starting EpsonNet Config (Web Version)" on
page 65.
To Next Page
Loading...
