Chapter 3 Application Development Information
87
3
Memory Switch Setting Mode
You can configure the memory switches of the printer.
Starting the memory switch setting mode
Follow the steps below to run this mode.
1
Close the roll paper cover.
2
Turn on the printer while pressing the Feed button. (Keep pressing the
Feed button until the printer starts printing.)
The printer prints current status of the printer.
3
After the printing has been completed, press the Feed button for more
than one second.
The printer starts printing instructions.
•Receive buffer capacity•BUSY condition
•Processing when data receive error • Auto line feed
•USB power-saving function • Release condition of receive buffer BUSY
•Error signal output •Print density
•Multi-tone print density•Print speed
•Character code table default
•International character default
•Interface selection •Autocutting after closing cover
•Auto paper reduction •Font auto replacement
•Buzzer control • Communication condition of serial interface
•Communication condition of USB
interface
•TM-T88V command-compatible mode (only for
ANK models)
For detailed information about memory switches, see "Setting the Memory Switches/
Receipt Enhancement" on page 54.
With the LAN interface, before printing starts, it takes 6 seconds if the IP address is fixed
and 13 seconds if the IP address is obtained with the automatic setting. (It may take longer
depending on the response time from the host.)
To Next Page
Loading...
