Epson TM-T70II - Auto Line Feed

56
Processing when data receive error
•Prints “?” (initial setting)
•Ignored
Auto line feed
•Always disabled (initial setting)
•Always enabled
USB power-saving function
•Disabled
•Enabled (initial setting)
Release condition of receive buffer BUSY
• Releases when the remaining receive buffer capacity becomes 256 bytes (initial setting)
• Releases when the remaining receive buffer capacity becomes 138 bytes
Paper sensor to output paper-end signals default (only for parallel
interface models)
•Paper end sensor enabled, paper near-end sensor enabled
•Disabled (initial setting)
Error signal output
•Enabled (initial setting)
•Disabled
Print density
Selectable from levels 1 to 13 (70%  130%)
Initial setting: level 7 (100%)
The USB power-saving function is valid only when the USB interface communication
condition is set to the vendor-defined class and the system configuration is set so that the
USB driver can support the USB power-saving function.
This function is enabled only when Receive buffer capacity is set to 4 KB.