Epson TM-T88V-i

126
 margin_top:(Optionalparameter,Objecttype:Number,Whennotspecified:0)
Specifiestopmargin(inunitsof0.1mm).
 margin_bottom:(Optionalparameter,Objecttype:Number,Whennotspecified:0)
Specifiesbottommargin(inunitsof0.1mm).
 offset_cut:(Optionalparameter,Objecttype:Number,Whennot
specified:0)
Specifiescutposition(inunitsof0.1mm).
Incaseofdiecutlabelpaper,itisadistancefromthebottomoflabel.
Whenapaperhasblackmark,itisadistancefromthebeginningofblackmark.
Paper Type Valid value range Description
Receipt 
(without black mark)
0 Setup not necessary
Receipt (with black mark) -150 to 1500 *
Distance from the top of
black mark
Die-cut label 
(without black mark)
0 to 1500 *
Distance from the top of
label
Die-cut label
(with black mark)
-15 to 1500 *
Distance from the bottom of
black mark
Paper Type Valid value range Description
Receipt 
(without black mark)
0
Setup not necessary
Receipt (with black mark) 0
Die-cut label 
(without black mark)
-15 to 0 *
Distance from the bottom of
label (paper feed direction
is a positive number)
Die-cut label
(with black mark)
-15 to 15 *
Distance from the top of
black mark (paper feed
direction is a positive num-
ber)
Paper Type Valid value range Description
Receipt 
(without black mark)
0 Setup not necessary
Receipt (with black mark) -290 to 50 *
Distance from the top of
black mark to the cutting
position
Die-cut label 
(without black mark)
0 to 50 *
Distance from the bottom of
label to the cutting position
Die-cut label
(with black mark)
0 to 50 *
Distance from the top of
black mark to the cutting
position