184
layout property
It sets paper layout. (in firmware Ver.2.2 and later)
Object type
Object
Description
It specifies paper layout.
Property of layout being setup
Value of width (Object type : Number, When not specified : 580)
Specifies paper width (in units of 0.1mm). Specifies an integer from 290 to 600. *
Value of height (Object type : Number, When not specified : 0)
Specifies paper height (in units of 0.1mm).
Property Name Object type
width Paper width Number
height Paper height Number
margin_top Top margin Number
margin_bottom Bottom margin Number
offset_cut Cutting position Number
offset_label Bottom position of label Number
Paper type Valid value range Description
Receipt
(without black mark)
0 Setup not necessary
Receipt (with black mark)
0 (auto)
284 to 1550 (manual) *
Distance from the top of black
mark to the top of next black
mark
Die-cut label
(without black mark)
Distance from the top of label to
the top of next label
Die-cut label
(with black mark)
Distance from the bottom of
black mark to the bottom of next
black mark
To Next Page
Loading...
Need help?
General