186
Value of offset_label (Object type : Number, When not specified : 0)
Specifies label bottom position (sd) per 0.1mm unit.
*: Valid value of range is depending on the printer model. For detail, refer to "Appendix - Printer
Specifications".
Layout property positions that can be designated for each type of paper
Paper type Valid value range Description
Receipt
(without black mark)
0 Setup not necessary
Receipt (with black mark) 0
Die-cut label
(without black mark)
0
Die-cut label
(with black mark)
0 to 15 * Distance from the top of black
mark to the bottom of label
Mark Parameter
sf width
sa height
sb margin_top
se margin_bottom
sc offset_cut
sd offset_label
sf sf
sf
sf
sb
sb
sc
sc
sc
sa
sa
sa
Receipt
Label
se
se
sb
sd
Cut
Cut
Cut
Bottom edge
of print area
Bottom edge
of print area
Standard eject
Top position
Bottom edge
of label
<with Black Mark>
sc
Top position
Top position
<without Black Mark>
To Next Page
Loading...
Need help?
General