2. Check if the translucent lm is smeared. Smears are easier to see if you use a light.
If there are smears (such as
nger
marks or grease) on the translucent
lm
(A), go to the next step.
A
B
A: Translucent lm
B: Rail
c
Important:
Be careful not to touch the rail (B). Otherwise, you may not be able to print. Do not wipe
o
the grease on the
rail, because this is necessary for operations.
3. Moisten a cotton swab with the water with a few drops of detergent so that it is not dripping water, and then
wipe the smeared part.
c
Important:
Wife o the smear gently. If you press the cotton swab too hard to the lm, the springs of the lm may be
dislocated and the printer may be damaged.
4. Use a new dry cotton swab to wipe the lm.
c
Important:
Do not leave any bers on the lm.
User's Guide
Maintaining the Printer
157
To Next Page
Loading...
