MINI-LINKEandEMicro
4.6 Filter Unit
4.6.1 RF Loop
The RF Loop is used for test purposes only. When the loop is set, the transmitter
frequency is set to receiver frequency and transferred to the receiving side.
4.6.2 Branching Filter
On the transmitting side, the signal is fed to the antenna through an output
branching filter. The signal from the antenna is fed to the receiving side through
an input branching filter. The antenna and both branching filters are connected
with an impedance T-junction.
88
AE/LZT 110 2012 R8C 2002-03-04
To Next Page
Loading...