Ericsson SmartEdge 600 - Card Descriptions; Controller Cards

Card Descriptions
6 Card Descriptions
The SmartEdge 600 router supports XCRP4 Controller card and the following
line cards.
Table 82 SmartEdge Line Cards
Line Card Type and Card Description
Physical
Ports
Low-Density
Version
Low-Density
Port Numbers
Enhanced ATM OC-12c/STM-4c IR (1-port)
ATM OC-3c/STM-1c (4-port)
ATM OC-3c/STM-1c (8-port)
1
4
8
No
Yes
No
–
1, 3
–
OC-192c/STM-64c (1-port)
POS OC-48c/STM-16c (4-port)
POS OC-12c/STM-4c (4-port)
POS OC-3c/STM-1c (8-port)
1
4
4
8
No
No
No
No
–
–
–
–
10/100 Ethernet (12-port)
Fast Ethernet–Gigabit Ethernet (60-port FE, 2-port GE)
Gigabit Ethernet (4-port)
Advanced Gigabit Ethernet (4-port)
Gigabit Ethernet 3 (4-port)
Gigabit Ethernet 1020 (10-port)
Gigabit Ethernet 1020 (20-port)
(1)
Gigabit Ethernet (5-port)
Gigabit Ethernet (20-port)
(2)
10 Gigabit Ethernet (1-port)
10 Gigabit Ethernet (4-port)
12
60, 2
4
4
4
10
20
5
20
1
4
No
No
Yes
Yes
No
No
No
No
No
No
No
–
-
1, 3
1, 3
–
–
–
–
–
–
–
(1) The 20-port GE1020 card requires two adjacent slots.
(2) Because the TX SFP is larger than a standard SFP, you cannot insert two TX SFPs side by side on the 20-port
GE line card.
Gigabit Ethernet applies to any Ethernet line card that supports a port speed of
1 Gbps or greater; unless explicitly stated, the speed of any Gigabit Ethernet
port is 1 Gbps.
A few line cards have a low-density version on which a limited number of ports
are enabled through software entitlement.
Each pair of facility LEDs on the transceiver-based Gigabit Ethernet cards
indicates status for its associated port.
These transceivers are described in Transceivers for SmartEdge and
SM Family Line Cards.
107
27/153 30-CRA 119 1170/1 Uen A | 2010-04-09