Hardware Control and Troubleshooting
3.8 Output Fields for the show port Command
Table 44 Output Fields for the show port Command
Field Value/Description
Slot/Port slot/port—Slot and port numbers for this port.
Type
port-type
State Port status (combination of the Admin state and Line state fields):
• Down—Port has been configured to be Up, but is not working.
• Down - not entitled—Port is on the low-density version of the line card and is not available.
• No card—Port has been configured, but the card is not installed.
• Unconfigured—Port is not configured and down.
• Up—Port is working (active).
Table 45 Port Types
Port Type Description
atm
ATM OC-3c/STM-1c or ATM OC-12c/STM-4c
pos
OC-192c/STM-64c, POS OC-3c/STM-1c, POS OC-12c/STM-4c, or POS
OC-48c/STM-16c
ethernet Ethernet or GE port (any version)
transceiver SFP or XFP transceivers port
Not all fields apply to all types of ports; in most cases this command displays
only the fields that are applicable to the type of port. The “Type” and “Slot/Port”
field names are not displayed in the output.
Table 46 Output Fields for the show port Command with the detail Keyword
Field Value/Description
Header
Type
port-type or channel-type.
Slot/Port slot/port—Slot and port numbers for this port.
State Port status (combination of the and fields) for a line card:
• Down—Port has been configured to be up, but is not working.
• Down—not entitled—Port is on the low-density version of the line card and is not available.
• No card—Port has been configured, but the card is not installed.
• Unconfigured—Port is not configured and down.
• Up—Port is working (active).
Port Parameters (in alphabetical order)
6327/153 30-CRA 119 1170/1 Uen A | 2010-04-09
To Next Page
Loading...
