Installing the Hardware
2.8.2 Local or Remote Console Terminal
Figure 18 Connections for a Local or Remote Console
A local or remote console terminal is connected to the SmartEdge 600 router
using the Craft port on the front of a controller card. This type of connection
provides access to the operating system CLI, either directly or through a
terminal server.
A null modem is needed when connecting this cable to a modem; it is not
needed when connecting it to a PC or terminal server.
This port is always available; all system messages are directed to this port
during a power on or reload operation.
Note: When you first power on the system, the active controller card is in slot
6. Thereafter, the slot changes whenever a switchover occurs.
2.9 Connections for External Timing Cables
Figure 19 Connections for External Timing Cables
41
27/153 30-CRA 119 1170/1 Uen A | 2010-04-09
To Next Page
Loading...
