Card Descriptions
Table 135 Equipment LEDs on 5-Port Gigabit Ethernet Card
Label Activity Color Description
On Green This card is in service.ACTIVE
Off None This card has failed (the FAIL LED is on).
(1) A failure can be total, partial, or forced. Failure on any part of the card, including failure of any of its ports, results in
the FAIL LED being on.
Table 136 Facility LEDs on 5-Port Gigabit Ethernet Card
Label Activity Color Description
On Yellow The link is transmitting or receiving frames.ACT
Off None The link has no active frame.
On Green The link is up.LNK
Off None The link is down.
6.17 20-Port Gigabit Ethernet Card
The 20-port Gigabit Ethernet (GE) card is designed to be used as a
subscriber-facing module and as well as a network uplink module. This card is
based on the third generation of the PPAs and has increased memory capacity
with a maximum throughput of 20 Gbps and increased port density compared
with previous GE cards. It supports up to 48K circuits per card.
This card is the same size as all other SmartEdge line cards and occupies a
single slot in the chassis. The following types of SFP optical transceivers are
supported on any of the ports:
• 100Base-FX—Short Reach
• 1000Base-SX—Short Reach
• 1000Base-LX—Long Reach
• 1000Base-ZX—Extended Reach
• 1000Base-TX—Copper
• 1000Base-CWDM—Coarse wavelength-division multiplexing
• 1000Base-DWDM—Dense wavelength-division multiplexing
149
27/153 30-CRA 119 1170/1 Uen A | 2010-04-09
To Next Page
Loading...
