Installing the Hardware
2.2 Install the Chassis
Warning!
Risk of personal injury. Do not lift or move the chassis without the aid of another
trained person A fully loaded chassis can weigh as much as 94 lb (42.6 kg) and
can cause injury if one person attempts to lift or move it. Always follow the
procedures at this installation site for safely lifting heavy objects.
Install the chassis in the rack:
1. With another installation engineer, lift the chassis to the position selected
in the rack.
2. Line up the screw holes in the mounting brackets with the screw holes
in the rack.
3. With one engineer holding the chassis in place, use the Phillips screwdriver
to secure the shelf to the rack using fasteners of the type compatible with
the rack. Tighten the fasteners to the vendor recommended torque level.
2.3 Install the Cable Management Brackets
Figure 5 Installing the Cable Management Brackets
23
27/153 30-CRA 119 1170/1 Uen A | 2010-04-09
To Next Page
Loading...
