SmartEdge 600 Router Hardware Guide
Table 9 Options for Management Access
Option Equipment Requirements
Craft 2 port connection to a local
console terminal
Local terminal—choose one of the following options:
• ASCII/VT100 console terminal or equivalent that runs at 9600 bits per second, 8 data bits, no
parity, 1 stop bit.
• PC or workstation in the same configuration as the ASCII/VT100 terminal.
Terminal server.
Craft console cable (shipped with the system).
Craft 2 port connection to a
remote console terminal
Local terminal—choose one of the following options:
• ASCII/VT100 console terminal or equivalent that runs at 9600 bits per second, 8 data bits, no
parity, 1 stop bit.
• PC or workstation in the same configuration as the ASCII/VT100 terminal.
A modem that runs at 56 kbps (maximum), 8 data bits, no parity, 1 stop bit, or terminal server.
Modem or terminal server cable.
1.13 Gathering Cables and Tools
You need cables for the following connections:
• Line card cables:
0
Ethernet cards
0
Gigabit Ethernet cards
• Operations cables:
0
Console terminal and management workstation (RS-232, LAN)
0
External timing (one or two, optional)
• Power cables:
0
DC power (four or eight)
0
Chassis ground (two)
If you intend to build your own cables, see Management Access Cables for
cable and connector specifications.
Table 10 Tools Needed for SmartEdge 600 Hardware Installation
Tool Purpose
Heavy-duty cart Transport chassis and system equipment from the receiving area to the installation
site.
Power lifter Optional (depending on installation scenario). Position the chassis in the rack.
12 27/153 30-CRA 119 1170/1 Uen A | 2010-04-09
To Next Page
Loading...
