SmartEdge 600 Router Hardware Guide
Table 49 XFP Auxiliary Measurements Displayed by the show port Command with the detail
Keyword
Field Range
APD bias voltage (16-bit value is Voltage in units of 10 mV) 0001b
Reserved 0010b
TEC current (mA) (16-bit value is Current in units of 100 uA) 0011b
Laser temperature (same encoding as module temperature) 0100b
Laser wavelength 0101b
+5V Supply voltage 0110b
+3.3V Supply voltage 0111b
+1.8V Supply voltage 1000b
-5.2V Supply voltage (absolute value encoded as primary voltage monitor) 1001b
+5V Supply current (16-bit Value is Current in 100 uA) 1010b
+3.3V Supply current (16-bit Value is Current in 100 uA) 1101b
+1.8V Supply current (16-bit Value is Current in 100 uA) 1110b
-5.2V Supply current (16-bit Value is Current in 100 uA) 1111b
3.10 Troubleshoot with System and Card LEDs
To ensure that the system LEDs are working, press the alarm cutoff (ACO)
button for more than three seconds to light all working LEDs on the fan tray.
The LEDs remain lit as long as the ACO button is pressed.
3.11 Troubleshoot with System Power and Alarm LEDs
In most cases, the overall status of a SmartEdge 600 system is indicated by
the two sets of LEDs located on the front of the fan and alarm unit. If you are
experiencing hardware problems, check the LEDs to determine the possible
cause and solution. Table 3-20 lists the problems that are indicated by the
system power and alarm LEDs.
Table 50 Common Terms
Term Description
controller card Refers to any version of the Cross-Connect Route Processor (XCRP) Controller card (XCRP4),
unless otherwise noted.
Gigabit Ethernet Applies to any Ethernet Line Card that supports a port speed of 1 Gbps or greater; unless explicitly
stated, the speed of any Gigabit Ethernet port is 1 Gbps.
Table 51 Definitions of Terms
Term Definition
ADM Add-drop multiplexer
72 27/153 30-CRA 119 1170/1 Uen A | 2010-04-09
To Next Page
Loading...
