SmartEdge 600 Router Hardware Guide
7.1 LEDs
Figure 54 LEDs on ASE Card
Table 152 Equipment LEDs on the ASE Card
Label Activity Color Description
On Red A failure exists on the card.
(1)
FAIL
Off None No failure exists on the card.
On Green This card is in service.ACTIVE
Off None This card is on standby (the STDBY LED is on) or has failed (the FAIL LED is
on).
On Yellow This card is on standby.STDBY
Off None This card is in service (the ACTIVE LED is on) or has failed (the FAIL LED is
on).
(1) A failure can be total, partial, or forced. Failure on any part of the card, including failure of any of its ports, results in
the FAIL LED being on.
Table 153 Facility LEDs for the ASE Card
Label Activity Color Description
On Green The link is present and active.
On Blinking The link is transmitting or receiving frames.
LNK ACT
Off None The link has no active frame.
On Yellow
(1)
The link is operating at 100 Mbps.
On Green The link is operating at 1000 Mbps.
SPD
On Green The link is operating at 10 Mbps.
(2)
(1) The default condition for no link or cable attached is yellow.
(2) The LED shows green for both 10 and 1000 Mbps.
160 27/153 30-CRA 119 1170/1 Uen A | 2010-04-09
To Next Page
Loading...
