Ericsson SmartEdge 600 - 4-Port POS OC-12 c;STM-4 c Card

SmartEdge 600 Router Hardware Guide
Table 97 Equipment LEDs on 8-Port POS OC-3c/STM-1c Card
Label Activity Color Description
On Yellow At least one of the ports on this card has been configured as a protection port.
(2)
STDBY
Off None None of the ports on this card has been configured as a protection port.
(1) A failure can be total, partial, or forced. Failure on any part of the card, including failure of any of its ports, results in
the FAIL LED being on.
(2) Protection for cards and ports depends on the release of the SmartEdge OS.
Table 98 Facility LED on 8-Port POS OC-3c/STM-1c Card
Label Activity Color Description
On Yellow This port has been configured and enabled, but is experiencing an LOS.LOS
Off None This port is in one of the following states:
• Has been configured (provisioned) and enabled, and is receiving or
transmitting traffic.
• Has been configured, but is currently disabled.
• Has not yet been configured.
6.6 4-Port POS OC-12c/STM-4c Card
The 4-port POS OC-12c/STM-4c card functions as a network uplink module in
edge routing and BRAS applications. This card is a PPA2-based card and has
a minimum memory capacity of 1 GB.
This POS OC-12c/STM-4c card supports PPP, HDLC, FR encapsulations,
MDRR, and POS LAG features.
This card is the same size as all other SmartEdge line cards and occupies a
single slot in the chassis. This card requires a separate SFP transceiver for
each port.
The following types of SFP transceivers are supported on any of the ports:
• SONET OC-12c/STM-4 SR-1—Short Reach
• SONET OC-12/STM-4 IR-1—Intermediate Reach
Table 99 4-Port POS OC-12c/STM-4c Card Specifications
Specification SR-1 IR-1
General
Number of ports
(1)
44
Speed 622.08 Mbps 622.08 Mbps
Protection (facility)
(2)
• None
• 1+1 APS: Bidirectional;
revertive or nonrevertive
switching
• None
• 1+1 APS: Bidirectional;
revertive or nonrevertive
switching
124 27/153 30-CRA 119 1170/1 Uen A | 2010-04-09