Card Descriptions
Table 122 Equipment LEDs on 4-Port GE3 Card
Label Activity Color Description
On Green This card is in service.ACTIVE
Off None This card has failed (the FAIL LED is on).
(1) A failure can be total, partial, or forced. Failure on any part of the card, including failure of any of its ports, results in
the FAIL LED being on.
Table 123 Facility LEDs on 4-Port GE3 Card
Label Activity Color Description
On Yellow The link is transmitting or receiving frames.ACT
Off None The link has no active frame.
On Green The link is up.LNK
Off None The link is down.
6.14 10-Port Gigabit Ethernet 1020 Card
The 10-port Gigabit Ethernet 1020 (GE1020) card is designed for traffic
management by using the second generation of the PPAs, each of which
supports 1 GB of memory and can process data internally to match the speed
of the ports. This GE1020 card provides 10 optical ports, each of which runs at
1 Gbps.
This card is the same size as all other SmartEdge line cards and occupies a
single slot in the chassis. The following types of SFP optical transceivers are
supported on any of the ports:
• 1000Base-SX—Short Reach
• 1000Base-LX—Long Reach
• 1000Base-ZX—Extended Reach
• 1000Base-TX—Copper
• 1000Base-CWDM—CWDM
• 1000Base-DWDM—DWDM
Caution!
Risk of data loss. You can corrupt the system if you attempt to install
transceivers (GBICs, SFPs, or XFPs) that are not purchased from Ericsson
because these items have not been tested with the SmartEdge router. To
reduce the risk, install only the transceivers purchased from Ericsson.
14127/153 30-CRA 119 1170/1 Uen A | 2010-04-09
To Next Page
Loading...
