Ericsson SmartEdge 600 - CLI Commands for Hardware Control

SmartEdge 600 Router Hardware Guide
Table 30 CLI Commands for Hardware Status
Task or Information Needed CLI Command Comments
Status of the SmartEdge Service Engine (SSE)
card
show administrators
show chassis
show chassis power
show configuration
show configuration sse
show disk sse
show disk sse counters
show hardware
show sse {group | partition}
show sse counters
show system alarm sse
These show commands display
a variety of information about the
SSE card. The information contains
software version information, system
uptime, task information, configuration
information, and current state of the
card.
Status of all alarms at system, slot, port, and
transceiver level
show system alarm
When reporting alarms and warnings
of the transceivers, the SFP
transceivers must be compliant to
SFF-8472 and the XFP transceivers
must be compliant to INF-8077i.
Status of alarms for specific slot, port, or
transceiver
show system alarm all
The show system alarm all
command reports the status of alarms
for specific transceiver or SNMP trap
system alarm, Transceiver alarm
reporting (including corresponding
SNMP traps) is disabled by default.
Status of alarms for specific transceiver or
SNMP trap
system alarm
Transceiver alarm reporting (including
corresponding SNMP traps) is
disabled by default.
Status of the ASE card
show tech-support ase
Helps your technical support
representative resolve issues on the
ASE card. The command shows
software version information, system
uptime, task information, configuration
information, and current state of each
line card.
3.2 CLI Commands for Hardware Control
Required characters and keywords for commands are shown in bold; arguments
for which you must supply a value are shown in italic.
Table 31 CLI Commands for Hardware Configuration and Control
Task or Information Needed CLI Command Comments
Shut down, restart hardware
(1)
Shut down (disable) a port
port port-typeslot/port
shutdown
The shutdown command disables
the port, but does not clear counters;
use theclear port counters
command to clear the counters for a
specific port.
50 27/153 30-CRA 119 1170/1 Uen A | 2010-04-09