Card Descriptions
Table 141 Facility LEDs on 20-Port Gigabit Ethernet Card
Label Activity Color Description
On Green The link is up.LNK
Off None The link is down.
6.18 1-Port 10 Gigabit Ethernet Card
The 1-port 10 Gigabit Ethernet (1x10GE) card is designed for traffic
management by using the second generation of the PPAs, each of which
supports 1 GB of memory and can process data internally to match the speed
of the port, which runs at 10 Gbps.
The port on this line card can be configured as LAN-PHY at 10320 Mbits/s, or
WAN-PHY at 9953.25 Mbits/s.
This card is the same size as all other SmartEdge line cards and occupies
a single slot in the chassis. Any of the following types of 10-Gbps XFP
transceivers are supported on any of the ports:
• 10GE-SR
• 10GE-LR
• 10GE-ER
• 10GE-ZR
• 10GE-DWDM
Caution!
Risk of data loss. You can corrupt the system if you attempt to install
transceivers (GBICs, SFPs, or XFPs) that are not purchased from Ericsson
because these items have not been tested with the SmartEdge router. To
reduce the risk, install only the approved transceivers.
Note: When ordering the XFP transceivers with 10GE ZR functionality, use
part number XFP-OC192-LR2.
Table 142 1-Port 10 Gigabit Ethernet Card XFP Specifications
Specification SR LR ER ZR
(1) (2)
Number of ports
(3)
1111
Speed
(4)
10.3125 Gbps 10.3125 Gbps 10.3125 Gbps 10.3125 Gbps
Protection None None None None
15327/153 30-CRA 119 1170/1 Uen A | 2010-04-09
To Next Page
Loading...
