SmartEdge 600 Router Hardware Guide
8.3 Provision and Configure the SSE Card
Configuring an SSE card involves provisioning the SSE card, partitioning the
disks, and setting up a redundancy scheme. For detailed information about
how to configure and operate an SSE card, see related documentation at
https://ebusiness.ericsson.net.
8.4 SSE Operational Commands
The following are SSE operational commands:
• clear disk sse counters—Clears counters on the SSE in the
specified slot or on the specified disk of the SSE card.
• clear sse group counters—Clears counters on the specified SSE
group. This command does not persist over the following events:
0
SSE group switchover
0
XCRP switchover
0
card reload
0
system reload
0
disk removal
0
disk insertion
• debug fsm group—For field and development debugging of SSE
group-specific operations.
• debug fsm partition—For field and development debugging of SSE
partition-specific operations.
• delete partition—Removes the specified partition on an SSE disk.
All data in the partition is deleted.
Note: This delete partition command cannot be executed if the partition is
mounted on the XCRP or Advanced Services Engine (ASE) card.
• diag on-demand—Runs diagnostics on the SSE card in the specified
slot. Before running diagnostics on the SSE card, make sure to disable the
SSE card or the specified disk on the SSE card by using the shutdown
command.
• format sse—Formats the specified disk on the SSE card, removing all
user-configured partition and data.
Note: The SSE card cannot be bound to an SSE group when issuing
format sse command.
166
27/153 30-CRA 119 1170/1 Uen A | 2010-04-09
To Next Page
Loading...
