SmartEdge Storage Engine
• reload card—Shuts down the card for removal and reinsertion.
• reload disk—Shuts down the specified SSE disk and reloads the disk.
This command is equivalent to removing and reinserting the disk.
Note: If you issue this reload disk command on the active card during
data synchronization on any partition, a warning message appears.
• show administrators—Displays administrator sessions on a system.
• show chassis—Displays installed and configured cards and their status.
• show chassis power—Displays power allocation for the current
SmartEdge chassis configuration.
• show configuration—Displays current configuration of the SmartEdge
router or the contents of the previously saved configuration file on the local
file system.
• show configuration sse—Displays current configuration of all SSE
cards on the system.
• show disk—Displays disk info for the SSE card.
• show disk sse counters—Displays disk counters for the SSE card.
• show hardware—Displays information about the system hardware.
• show sse group | partition—Displays SSE group or SSE partition
counters.
• show sse group | partition counters—Displays SSE group or
SSE partition information.
• show system alarm—Displays system-level alarms.
• show version—Displays current version of the software running on the
system.
• sse group switch-over—Performs a manual switchover on an SSE
group configured with redundancy to the standby SSE card or disk. The
standby SSE card or disk must be available.
• telnet to SSE—Accesses the SSE Linux shell via telnet from the
XCRP’s management interface for development and debugging purposes
only.
• UNIX/DOS Commands—Allows you to utilize the UNIX/DOS commands
supported on the CLI. For users with CLI admin privileges only.
For more information on SSE-related commands, see related
documentation at https://ebusiness.ericsson.net.
167
27/153 30-CRA 119 1170/1 Uen A | 2010-04-09
To Next Page
Loading...
