Ericsson SmartEdge 600 - Install the Chassis Mounting Brackets

SmartEdge 600 Router Hardware Guide
2.1 Install the Chassis Mounting Brackets
FAN TRAY
1149
Figure 4 Installing Chassis Brackets for Flush Mount Position
Caution!
Risk of equipment damage. Always use the number and type of screws
specified in the instructions.
To install brackets:
1. Position a mounting bracket against one side of the chassis, lining up the
screw holes in the bracket with the screw holes in the side of the chassis.
2. Using a Phillips screwdriver, attach the bracket to the chassis with the
screws provided with the mounting bracket; tighten to a maximum torque of
15.0 inch-lbs (1.7 Newton-meters).
3. Repeat steps 1 and 2 to attach the second bracket to the other side of
the chassis.
22
27/153 30-CRA 119 1170/1 Uen A | 2010-04-09