SmartEdge 600 Router Hardware Guide
Table 130 Equipment LEDs on 20-Port Gigabit Ethernet 1020 Card
Label Activity Color Description
On Green This card is in service.ACTIVE
Off None This card has failed (the FAIL LED is on).
(1) A failure can be total, partial, or forced. Failure on any part of the card, including failure of any of its ports, results in
the FAIL LED being on.
Table 131 Facility LEDs on 20-Port Gigabit Ethernet 1020 Card
Label Activity Color Description
On Yellow The link is transmitting or receiving frames.ACT
Off None The link has no active frame.
On Green The link is up.LNK
Off None The link is down.
6.16 5-Port Gigabit Ethernet Card
The 5-port Gigabit Ethernet card is designed for traffic management with the
second generation of the PPAs, each of which supports 1 GB of memory and
can process data internally at a much higher rate than the PPAs on the first
and second versions of the Gigabit Ethernet card.
This card is the same size as all other SmartEdge line cards and occupies a
single slot in the chassis. The following types of SFP optical transceivers are
supported on any of the ports:
• 1000Base-SX—Short Reach
• 1000Base-LX—Long Reach
• 1000Base-ZX—Extended Reach
• 1000Base-TX—Copper
• 1000Base-CWDM—Coarse wavelength-division multiplexing (CWDM)
• 1000Base-DWDM—Dense wavelength-division multiplexing (DWDM)
Caution!
Risk of data loss. You can corrupt the system if you attempt to install
transceivers (GBICs, SFPs, or XFPs) that are not purchased from Ericsson
because these items have not been tested with the SmartEdge router. To
reduce the risk, install only the transceivers purchased from Ericsson.
146 27/153 30-CRA 119 1170/1 Uen A | 2010-04-09
To Next Page
Loading...
