Site Preparation
Table 18 Cable Specifications for Transceiver-Based Gigabit Ethernet Line Cards
Transceiver Description Card End
(1)
Cable End
Maximum
Distance
Multimode fiber 50/125 µm LC female LC male 656.2ft - 200.0m
LX SFP transceiver Single-mode fiber 9/125 µm LC female LC male 6.2mi - 10.0km
ZX SFP transceiver Single-mode fiber 9/125 µm LC female LC male 49.7mi -
80.0km
(3)
SR/SW XFP transceiver Multimode fiber 50/125 µm LC female LC male 984.4ft - 300.0m
LR/LW XFP transceiver Single-mode fiber 9/125 µm LC female LC male 6.2mi - 10.0km
ER XFP transceiver Single-mode fiber 9/125 µm LC female LC male 24.9mi - 40.0km
ZR XFP transceiver
(4) (5)
Single-mode fiber 9/125 µm LC female LC male 49.7mi - 80.0km
DWDM transceiver
(6)
Single-mode fiber 9/125 µm LC female LC male 49.7mi - 80.0km
(1) The SC connectors on the card are type SC/PC; cable and card connectors must match.
(2) To comply with GR-1089 intrabuilding lightning surge requirements, intrabuilding wiring must be shielded, and the
shield for the wiring must be grounded at both ends.
(3) When the port level lossless flow control is enabled, the distance reach is limited to 43.5 mi (70.0 km).
(4) The ZR XFP transceiver is a multi-rate device and can be used in the 10GE line card and the SONET/SDH
OC-192c/STM-64c LR line card.
(5) Use part number XFP-OC192-LR2 when ordering the XFP transceivers with 10GE ZR functionality.
(6) DWDM XFP transceivers support only ITU channels 35, 36, 37, 53, and 54; see ITU DWDM Transmit Frequencies
and Wavelengths table in Chapter 6 for the frequency and wavelength of each ITU channel; specified in ITU G.694.1.
1.17 Transceiver-Based SONET/SDH Line Card Cables
Table 19 Cable Specifications for the SONET/SDH Line Cards
Transceiver Type Description Card Connector
(1)
Cable Connector Maximum Distance
SR / MM Multimode fiber 62.5/125 µm LC female LC male 1,640.4 ft - 500.0 m
(2)
1.2 mi - 2.0 km
SR / SM
(3)
Single-mode fiber 9/125 µm LC, FC, or SC female LC, FC, or SC male 1.2 mi - 2.0 km
IR / SM
(3)
Single-mode fiber 9/125 µm LC female LC male 9.3 mi - 15.0 km
IR-2 / SM (with XFP
transceiver)
Single-mode fiber 9/125 µm LC female LC male 24.9 mi - 40.0 km
LR-1 / SM Single-mode fiber 9/125 µm LC female LC male 24.9 mi - 40.0 km
LR-2 / SM Single-mode fiber 9/125 µm LC female LC male 49.7 mi - 80.0 km
(1) The SC connectors on the card are type SC/PC; cable and card connectors must match.
(2) For SFP-OC12-MM transceiver, the maximum distance is 500 meters.
(3) Use part number SFP-OC3-SM-IR when ordering the SFP transceivers with POS OC-3 SR-1 or POS OC-3
IR-1 functionality.
1727/153 30-CRA 119 1170/1 Uen A | 2010-04-09
To Next Page
Loading...
