Ericsson SmartEdge 600 - 5-Port Gigabit Ethernet Card

SmartEdge 600 Router Hardware Guide
Caution!
Risk of data loss. You can corrupt the system if you attempt to install
transceivers (GBICs, SFPs, or XFPs) that are not purchased from Ericsson
because these items have not been tested with the SmartEdge router. To
reduce the risk, install only the transceivers purchased from Ericsson.
Table 137 20-Port Gigabit Ethernet Card Specifications (100Base-FX)
Specification
(1)
FX
Interface 100Base-FX
Link power budget
(2)
13.5 dB
Nominal wavelength
1310 nm
Connector type LC
Cable type MMF
Compliance SFF-8472 and INF-8074i
Transmitter
Optical output power –19.0 dBm (min)
–14.0 dBm (max)
Center wavelength range
1270 to 1380 nm
Extinction ratio 10.0 dB (min)
Center wavelength
1310 nm
Spectral width (RMS)
(3)
140.0 nm (max)
Receiver
Wavelength range
(4)
1270 to 1380 nm
Sensitivity –32.5 dBm (min)
–14.0 dBm (max)
Overload level 0.0 dBm (max)
(1) To display static transceiver data, enter the show hardware command (in any mode) with the card and detail
keywords, or, for dynamic data, enter the show port command (in any mode) with the detail keyword. Measured or
reported values may meet or exceed performance parameters that are specified in this table.
(2) Link power budget is calculated using (minimum output power) – (minimum sensitivity).
(3) Root mean square (RMS) value.
(4) Receiver sensitivity is degraded 1.0 dB for wavelengths
ˇ
S 1570 nm.
Table 138 20-Port Gigabit Ethernet Card SFP Specifications (1000Base-SX, LX, ZX, and TX)
Specification SX LX ZX TX
(1) (2)
Number of ports
(3)
20 20 20 20
Speed 1 Gbps 1 Gbps 1 Gbps 1 Gbps
Protection None None None None
150 27/153 30-CRA 119 1170/1 Uen A | 2010-04-09