SmartEdge 600 Router Hardware Guide
6.6.1 Status LEDs
Figure 40 Status LEDs on 4-Port POS OC-12c/STM-4c Card
Table 100 Equipment LEDs on 4-Port POS OC-12c/STM-4c Card
Label Activity Color Description
On Red A failure exists on the card.
(1)
FAIL
Off None No failure exists on the card.
On Green This card is in service.ACTIVE
Off None This card is either on standby (the STDBY LED is on) or has failed (the FAIL
LED is on).
On Yellow At least one of the ports on this card has been configured as a protection port.
(2)
STDBY
Off None None of the ports on this card has been configured as a protection port.
(1) A failure can be total, partial, or forced. Failure on any part of the card, including failure of any of its ports, results in
the FAIL LED being on.
(2) Protection for cards and ports depends on the release of the SmartEdge OS.
Table 101 Facility LED on 4-Port POS OC-12c/STM-4c Card
Label Activity Color Description
On Yellow This port has been configured and enabled, but is experiencing an LOS.LOS
Off None This port is in one of the following states:
• Has been configured (provisioned) and enabled, and is receiving or
transmitting traffic.
• Has been configured, but is currently disabled.
• Has not yet been configured.
126 27/153 30-CRA 119 1170/1 Uen A | 2010-04-09
To Next Page
Loading...
