SmartEdge 600 Router Hardware Guide
6.10.1 Status LEDs
Figure 44 Status LEDs on 60-Port Fast Ethernet Card
Table 112 Equipment LEDs on 60-Port Fast Ethernet Card
Label Activity Color Description
On Red A failure exists on the card.
(1)
FAIL
Off None No failure exists on the card.
On Green This card is in service.ACTIVE
Off None This card has failed (the FAIL LED is on).
(1) A failure can be total, partial, or forced. Failure on any part of the card, including failure of any of its ports, results in
the FAIL LED being on.
Table 113 Facility LEDs for 10/100 Ports on 60-Port Fast Ethernet Card
Label Activity Color Description
On Yellow This port is operating at 10 Mbps; the link is up.
Blinking Yellow This port is operating at 10 Mbps; the link is up and active.
On Green This port is operating at 100 Mbps; the link is up.
Blinking Green This port is operating at 100 Mbps; the link is up and active.
01 – 12
Off None This port is not configured (no link), no activity exists, or the link is down.
On Green The connector for these ports is selected (using the push button at the bottom
of the front panel).
01 – 12
13 – 24
25 – 36
37 – 48
49 – 60
Off None The connector for these ports is not selected.
134 27/153 30-CRA 119 1170/1 Uen A | 2010-04-09
To Next Page
Loading...
