SmartEdge 600 Router Hardware Guide
2.12 Power On and Off the System 46
3 Hardware Control and Troubleshooting 49
3.1 Hardware Status 49
3.2 CLI Commands for Hardware Control 50
3.3 CLI Commands for Hardware Troubleshooting 52
3.4 Values for CLI Input Arguments 52
3.5 Output Fields for the show chassis Command 53
3.6 Output Fields for the show disk Command 55
3.7 Output Fields for the show hardware Command 56
3.8 Output Fields for the show port Command 63
3.9 Output Fields for the show port transceiver Command 69
3.10 Troubleshoot with System and Card LEDs 72
3.11 Troubleshoot with System Power and Alarm LEDs 72
3.12 Troubleshoot with Card Status LEDs 81
3.13 Troubleshoot with On-Demand Diagnostics 81
3.14 Obtaining Assistance 87
4 Servicing Hardware 89
4.1 Adding a Second Controller Card 91
4.2 Replacing a Controller Card 91
4.3 Replacing a Transceiver 94
4.4 Cleaning Optical Connectors 97
4.5 Replacing the Fan Tray 98
4.6 Replacing the Air Filter 99
4.7 Remove and Replace an AC Power Module 100
5 System Overview 103
5.1 Specification Summary 103
5.2 Line Card Interfaces 103
5.3 Packet Mesh Architecture 104
5.4 Redundancy 104
5.5 Alarms 104
5.6 System Status 104
5.7 SmartEdge 600 Chassis 105
6 Card Descriptions 107
6.1 Controller Cards 108
6.2 8-Port ATM OC-3c/STM-1c Card 114
27/153 30-CRA 119 1170/1 Uen A | 2010-04-09
To Next Page
Loading...
