SmartEdge 600 Router Hardware Guide
Table 46 Output Fields for the show port Command with the detail Keyword
Field Value/Description
QoS Rate Maximum
(7)
QoS port-rate limiting value:
(8)
• 50 to 149 Mbps.
• Payload line-rate (150 Mbps).
Path Alarms • N/A—Not applicable to this type of port.
• NONE—No alarms are present.
For a complete list of conditions that can cause an alarm, see the Troubleshoot with System
Power and Alarm LEDs section.
Path Trace Length The maximum size that the TX path trace message can be set to.
Physical Layer • lan-phy
• wan-phy
PPPoE PADO Delay State of PADO delay:
• Not set—PADO delay is not configured.
• Set (n sec)—PADO delay is configured for n seconds.
Rx path-trace Received path trace data.
Report Only Alarms State of alarm reporting for an ATM OC port:
• Path alarms (report only): Payload label mismatch (PLM)
• Path alarms (report only): Path unequipped (UNEQ)
Alarm is reported, but the port is not shut down.
Scramble Status of X^43 + 1 payload scrambling for a POS port (on or off).
Speed • nnn Mbps—Speed of the 10/100 Ethernet port.
• nn Gbps—Speed of the Gigabit Ethernet port (any version).
• auto—Speed of the 10/100 Ethernet port has been determined by sensing the line.
Support Lossless Large MTU Status of this FE port on an FE-GE line card with regard to guaranteed lossless flow control for
jumbo frames:
• Disabled—Port supports this feature but is not enabled for it.
• Enabled—Port is enabled for this feature.
• Not Configurable—Port does not support this feature.
• Shutdown—Port is a member of a port group that is enabled for this feature and has been shut
down because it does not support it.
Temperature SFP Transceiver temperature
Tx C2 byte Rx C2 byte Value of the C2 byte:
• ATM OC ports—0x13.
• POS ports—0x16 or 0xcf.
Tx Fault Rx Fault
Fault status for the transmit or receive side of the SFP transceiver
installed in this port:
• LowPwrWarning—Measured power has dropped below the level needed by the transceiver to
maintain connectivity without errors.
• NoFault—No power fault has occurred.
• PwrFault—Measured power is outside the range displayed in the PwrMin and PwrMax fields by
the show hardware command (in any mode) with the detail keyword.
68 27/153 30-CRA 119 1170/1 Uen A | 2010-04-09
To Next Page
Loading...
