34
F
Fitting the Fascia and Finishing Installation
F1 Fitting the Fascia Panels
To avoid scratches or knocks to the fascia panels of this heater they must be fitted at the
complete conclusion of the installation process. It may be necessary to use the outer fascia to
initially locate the heater but then remove it again so that there is no chance of damage. Use the
soft gloves provided whenever handling the fascia.
There are four fascia types available with the DL850 / DL1100:
The fascia installation will depend on the fascia and cavity type. For:
Bevelled Sided, see section F2 on page 35,
Squared Lite, see section F3 on page 37,
Inset, see section F4 on page 39.
Never rub the fascia panels. Refer to cleaning instructions supplied with fascia.
To Next Page
Loading...
