44
G
Installation Checklist
Go through the following checklist to ensure you have installed the appliance correctly
□ Correctly sized cavity to suit your fascia and flue configuration
□ Correct clearances to combustibles and mantles around the fascia
□ An electrical isolating switch to the appliance, accessible after finished installation
□ Correctly sized gas supply with a pressure test point, ensuring adequate supply with all other
gas appliances in the dwelling running
□ A weather-tight installed Horizontal or Vertical Powerflue Terminal with clearance as
specified by AS/NZ5601
□ Reasonable access to the outside face of the Horizontal Powerflue Wall Terminal for
maintenance purposes OR
□ Access to the Vertical Power Flue Enclosure for maintenance purpose
□ Flue attached to the rear/bottom of the Powerflue Terminal leading back to the appliance
□ The electrical cable from the Powerflue Terminal attached to the rear of the installation and
run back to the appliance cavity in an electrically safe manner
□ The appliance fixed to the cavity base and wall lining
□ The appliance plugged into a mains electricity supply
□ All gas joints and pressure points leak tested, and soapy water and drop tests completed on
gas pipework
□ Gas type conversion process carried out if required
□ Log, coal, river stone or crystalight fuel bed correctly installed
□ Glass correctly fitted
□ A completely fitted fascia
□ The remote control mounted on its cradle on a wall
□ Operated the fire and verified that it lights reliably and safely
□ Run the appliance on full for an hour with the doors & windows open
□ Appliance functions checked, including thermostat operation, Flame Eect and Fan Boost
□ Dwelling owner shown how to operate the appliance correctly
□ Warranty card filled in with installer details and appliance serial number
□ User Guide made available for end user
□ Plumbing Industry Commission Compliance Certificate given to end user
To Next Page
