Escea DL850 - Cleaning the Glass

B
ACDEFGSERVICE
43
For further operation instructions please refer to the User Guide.
F7 Normal Operating Sounds and Smells:
NOTE: Each time the fire is lit from cold the glass may fog up with condensation. This is normal and
the condensation will disappear within a few minutes once the glass heats up.
Sounds
It is possible that you will hear some sounds from your gas appliance. This is perfectly normal due
to the fact that there are various types of materials used within your appliance. Listed below are
some examples. These are all normal operating sounds and should not be considered as defects
in your appliance.
• Fan
Escea gas appliances use electric fans to push heated air further into the room. It is not
unusual for the fan to make a “whirring” sound when ON. This sound will increase or
decrease in volume depending on the speed setting of your fan.
• Gas Control Valve
As the gas control valves turn ON and OFF, a dull clicking sound may be audible, this is
the normal operation of a valve. When the fire is switched o after being run for a while,
there may be popping and fluttering noises as the residual gas in the burners burns away.
These are normal and should be no cause for concern.
• Unit Body/Firebox
Dierent types and thicknesses of steel will expand and contract at dierent rates resulting
in some “cracking” and “ticking” sounds being heard throughout the heating and cool down
processes.
Smells
The first few times the unit is operated, the unit may release an odour and the flames will appear
orange caused by the curing of the paint, the burning o of the starch in the gas logs and the
oils in the metal. This is a temporary curing process which will disappear with use.
F8 Cleaning the Glass
A deposit on the inside of the glass, caused by the starch in the logs, may appear as a build up
after several uses. If this film is not removed, it will bake on and may become dicult to remove.
When the glass is cold, remove it and clean the inside with a non-abrasive cleaner.
DO NOT ATTEMPT TO CLEAN THE GLASS WHILE IT IS HOT. NEVER OPERATE THE
UNIT WITH THE GLASS REMOVED.