Eureka Manta Manual Page 47 of 67
E.8.b Changing EBP Batteries and Activating Logging
1 Replace all batteries at the same time and use the same brand of battery.
2 Clean all moisture, dirt, grit and any other debris off the Manta because you are going to expose
sealing surfaces as you change the batteries.
3 Unscrew the black knob at the top of the EBP it until the battery sleeve detaches from the EBP body.
4 R
emove the spent batteries and install eight C-cell batteries (or six D-cell batteries) carefully following
the polarity diagram.
5 Clean all moisture, dirt, grit and any other debris off the exposed O-ring surfaces and the inside of the
battery sleeve. Add a small amount of silicone grease to the O-rings and to the inside of the battery
sleeve where the O-rings will seat.
6 Carefully screw the battery sleeve back into place. You don’t have to tighten it closely to the EBP
body; finger-tight is fine.
7 Remember that you must first activate Manta Logging by clicking the “Manta2 Logging is OFF” Hot
Button so that it changes to “Manta2 Logging is ON”. (C.3, E.5)
To Next Page
Loading...
