EUTECH INSTRUMENTS pH 600 User Manual

94
Resistivity Settings Page 2 – Hi-Lo Set Points
Figure 45: Resistivity Settings Page 2 – Hi-Lo Set Points
This page allows you to select alarm limits for resistivity measurement mode:
Parameter Description Factory Default
Alarm Set
Points
Set alarm limits for the resistivity measurement mode:
ENABLE – The measurement screen shows HI or LO
alarm indicators when the meter reading is above ‘HI
alarm value’ or below ‘LO alarm value’ specified in HI
& LO
Ω parameters (below)
DISABLE – HI and LO alarms are not shown in the
LCD
DISABLE
Hi Ω
Specify Hi alarm value here. The Hi alarm occurs
when the resistivity reading goes above this value
(This parameter is not editable when ‘ALARM SET
POINT’ is disabled)
2.00
Ω
Lo Ω
Specify Lo alarm value here. The Lo alarm occurs
when the resistivity reading goes below this value
(This parameter is not editable when ‘ALARM SET
POINT’ is disabled)
1.00
Ω
) Press (Up) or (Down) arrow key to set high or low alarm point.

EUTECH INSTRUMENTS pH 600 Specifications

General

Brand	EUTECH INSTRUMENTS
Model	pH 600
Category	Measuring Instruments
Language	English