*IMPORTANT – PLEASE READ BEFORE YOU CONTINUE*
PLEASE USE THIS MANUAL IN THIS ORDER :
Step 1:
Use the first half of this manual “General Guide” and “Temperature” to set up and
calibrate your instrument (Pages 1 - 39).
Step 2:
Then go to the specific parameter guides (eg. pH, Conductivity, TDS etc) which are
relevant to the model you have purchased. (Pg 41 onwards).
CAUTION: Do not skip the general guide as your meter will not be configured to read
accurately if your set-up and calibrations are not done accordingly.
Thank you for reading this page. Please proceed.
To Next Page
Loading...
