ECM-3610/3610L
ECM-3610/3610L User’s Manual 67
4.5.6.2 Power Management
This category allows you to select the type (or degree) of power saving and is directly
related to the following modes:
1. HDD Power Down
2. Doze Mode
3. Suspend Mode
There are three selections for Power Management , both of them have fixed mode
settings.
Min. Power Saving Minimum power management,
HDD Power Down = Disabled,
Doze Mode = 1 Hour
Suspend Mode = 1 Hour
Max. Power Saving Maximum power management,
HDD Power Down = Disabled,
Doze Mode = 1 Min
Suspend Mode = 1 Min
User Defined Allows you to set each mode individually. When not
disabled, each of the ranges are from 1 min. to 1 hr.
except for HDD Power Down which ranges from 1 min.
to 15 min. and disable.
4.5.6.3 PM Control by APM
This item allows you to enable/disable the Advanced Power Management (APM) function.
The choice: Yes, No.
4.5.6.4 Video Off Method
This determines the manner in which the monitor is blanked.
V/H SYNC+Blank This selection will cause the system to turn off the
vertical and horizontal synchronization ports and write
blanks to the video buffer.
Blank Screen This option only writes blanks to the video buffer.
DPMS Initial display power management signaling.
4.5.6.5 MODEM Use IRQ
This determines the IRQ in which the MODEM can use.
The choice: 3, 4, 5, 7, 9, 10, 11, or NA.
To Next Page
Loading...