EverFocus ECOR2 - Alarm & Event Setting; Alarm

54
4.5 ALARM & EVENT SETTING
Figure 4-10 is a screenshot of the ALARM & EVENT SETTING MENU. This menu will guide you through
alarm and event setup.
Figure 4-10 Alarm & Event Menu - Alarm
4.5.1 Alarm
Alarm: Select the alarm input trigger connection number from 1 to 4 (or 9 or 16 – one trigger per camera
input).
Enable: Check box to enable response to that alarm trigger.
Log: Check box to record these alarm events in the log.
Pre-alarm Record: Check box to start copying recorded video to the hard disk from 5 seconds before the
alarm event. (Pre-alarm recording rate will follow the “Normal” frame rate setting)
Buzzer: Check this box to enable the buzzer when an alarm occurs.
Main Monitor: Main monitor display options when a motion occurs.
No change: No change on the main monitor display.
Full screen: A full screen of the active camera will display on main monitor.
Call Monitor: Call monitor display options when a motion occurs.
No change: No change on the call monitor display.
Full screen:
A full screen of the active camera will display on call monitor.