Model 5600MSC Master Clock/SPG Manual
Page 2-6
Revision 1.6 INSTALLATION
2.1.10. HD SDI Test Generator Connections (HTG Option)
The HD TEST GEN group of sub-menus on the OUTPUT Setup menu is used to configure the HD SDI
test generator outputs. (See section 3.6.7.)
TG GEN LOCK Input BNC connector for an analog Genlock reference. The genlock signal may be a
HD tri-level sync or a standard definition colour black video or 0.3 V bi-level sync. The
input is terminated internally with 75 ohms and is normally connected to one of the sync
outputs from the 5600MSC.
HD SDI TG OUT This pair of BNC connectors has serial component video outputs compatible with the
SMPTE 292M standard. When the HTG Output Mode menu item is set to 4:4:4 these
outputs will contain the main channel (YC
B(even)
C
R(even)
or
GB
(even)
R
(even)
) part of the
test signal. The HD TEST SIGNALS sub-menu on the OUTPUT Setup menu selects the
test signal available on the HD SDI TG OUT connectors. (See section 3.6.8.)
HD SDI BLACK This pair of BNC connectors has serial component video outputs compatible with the
SMPTE 292M standard. When the HTG Output Mode menu item is set to 4:2:2 these
outputs will contain a black video signal. When the HTG Output Mode menu item is set
to 4:4:4 these outputs will the Alpha channel (YC
B(odd)
C
R(odd)
or
AB
(ODD)
R
(odd)
) part of
the test signal.
2.1.11. Power Connections
The 5600MSC has one or two (redundant supply is optional) universal power supplies that operate on
either 100-115 or 220-240 volts AC at 50 or 60 Hz and automatically senses the input voltage. Power
should be applied by connecting a 3-wire grounding type power supply cord to the power entry modules
on the rear panel. The power cord should be minimum 18 AWG wire size; type SVT marked VW-1,
maximum 2.5 m in length.
The IEC 320 power entry modules combines a standard power inlet connector, two 5 x 20 mm fuse
holders and an EMI line filter. For instructions on changing the fuses see section 4.3.1.
CAUTION - TO REDUCE THE RISK OF ELECTRIC SHOCK, GROUNDING OF THE
GROUND PIN OF THE MAINS PLUG MUST BE MAINTAINED
2.2. MOUNTING
The 5600MSC Master Clock/SPG is equipped with rack mounting angles and fits into a standard 19
inch by 1 3/4 inch (483 mm x 45 mm) rack space. The mounting angles may be removed if rack
mounting is not desired.
2.3. CONNECTING THE GENERAL PURPOSE INPUTS AND OUTPUTS
The 9 pin AUX I/O connector has 2 general purpose inputs and 2 general purpose outputs. The GPI
inputs are active low. This means that if you leave an input floating (not connected) then it will not be
activated. Lowering the GPI input to a voltage below 0.8 volts will activate the input. The user can
To Next Page
Loading...