evertz 5600MSC - Setting the SDI Embedded Audio Ident Mode; Setting the SDI Lip Sync Mode; Enabling the SDI Test Generator Moving Line; Selecting the SDI Video Test Generator Signal (STG Option Only)

Model 5600MSC Master Clock/SPG Manual
Page 3-38
Revision 1.6 OPERATION
3.6.5.4.5. Setting the SDI Embedded Audio Ident Mode
OUTPUT
SDI TEST GEN
STG Ident Type
Ident type tick
Ident type tone
The
STG Ident Type menu item is used to select the type of left right ident
used when the
STG AUD x Freq menu item for a specific channel is set to
ident.
Select Ident tick to use 30 msec duration burst of 1 KHz tone once per
second.
Select
Ident tone to use a continuous 1 KHz tone that decreases in level for
30 msec once every 4 seconds.
3.6.5.4.6. Setting the SDI Lip Sync Mode
OUTPUT
SDI TEST GEN
STG Lip sync
STG lip sync off
STG lip sync on
The
STG Lip sync menu item is used to select the whether the SDI test
generator output is modulated for lip sync purposes or not.
Select
STG lip sync on to add a pulsed modulation to the SDI video and
audio. The
STG lip sync mode overrides STG Audio Ident and is output on
the SDI, Analog and AES outputs.
3.6.5.5. Enabling the SDI Test Generator Moving Line
OUTPUT
SDI TEST GEN
STG Moving Line
STG move ln off
STG move ln on
The
STG Moving line menu item is used to select the whether there is a
moving line on the SDI test generator output or not.
Select
STG move ln on to add a horizontal black line with text in it that
moves continuously from the top to the bottom of the picture. This moving
line allows you to detect frozen video content.
3.6.6. Selecting the SDI Video Test Generator Signal (STG Option only)
OUTPUT
SDI TEST SIGNALS
This menu item allows you to select the test signal on the SDI test signal
generator output.
Use the arrow keys (
Ï, Ð) or turn the SHAFT ENCODER knob to select the
test signal. The name of the current test signal is shown on the front panel
display. Table 3-3 and Table 3-4 show the test signals that are available for
the 525 and 625 line video standards. Most of the test signals are industry
standard signals.
"
The front panel display will show WARNING LIVE CTL for 0.6 seconds to indicate
that changing the SDI Test Generator test signals will affect the Analog Test
Generator output immediately. You do not have to press the SELECT button to
accept the new values.
USO RESTRITO