evertz 5600MSC - Setting the VITC Time Zone; Enabling Daylight Saving Time Compensation on the VITC Output

Model 5600MSC Master Clock/SPG Manual
TECHNICAL DESCRIPTIONOPERATION
Revision 1.6 Page 3-27
3.6.2.3.9. Setting The VITC Time Zone
OUTPUT
SYNC 1 OUTPUT
Sync 1 Time Zone
S1 tz utc+00:00
This menu item allows the user to set a time zone offset between the
system time and the Sync 1 output’s VITC time. The time zone offset value
is in 30 minute increments from the system time which is normally running at
UTC. This time zone offset will be added to the system time along with the
Daylight Saving time correction (see section 3.6.2.3.10) and the Sync 1
offset (see section 3.6.2.3.8) to obtain the Sync 1 output’s VITC time.
Use the arrow keys (
Ï, Ð) or turn the SHAFT ENCODER knob to adjust the
time zone. When you have selected the desired time zone, press the
SELECT button to make this value active. The active time zone will be
blinking on the front panel.
This menu item is only applicable when the
Sync Standard is set to the
PAL-B or NTSC-M standards. The menu item will show the message
S1 no vitc in hd when the Sync Standard is set to one of the high
definition video standards.
3.6.2.3.10. Enabling Daylight Saving Time Compensation on the VITC Output
OUTPUT
SYNC 1 OUTPUT
Sync 1 DST En
S1 dst enabled
S1 dst disabled
This menu item allows the user to control whether Daylight Saving Time
compensation will be applied to the Sync 1 output’s VITC time.
When set to
S1 dst disabled, Daylight Saving Time compensation will not be
applied to the Sync 1 output’s VITC time information.
When set to S1 dst enabled the rules set by the DST RULES menu item on
the
GENERAL SETUP menu will be used to adjust the Sync 1 output’s VITC
time.
This menu item is only applicable when the
Sync Standard is set to the
PAL-B or NTSC-M standards. The menu item will show the message
S1 no vitc in hd when the Sync Standard is set to one of the high
definition video standards.
USO RESTRITO