EVOCA Opera - First Sterilisation of the Mixers and of the Food Product Circuits; Cup Sensor; Dispensing Unit Lighting; Button Leds

20 05 2013 4365 00
FIRST STERILISATION OF THE MIXERS
AND
OF THE FOOD PRODUCT CIRCUITS
When the machine is installed it is necessary to carry
out an accurate sterilisation of the mixers, of the instant
drinks dispensing pipes and of the internal tank in order
to ensure the hygiene of the distributed products.
Jets of water are to be absolutely avoided for clean-
ing.
The Sterilisation is performed by means of Sterilising
products.
Wash the mixers and add a few drops of sterilising solu-
tion
Once the sterilisation has been performed, rinse the mix-
ers well for removing any possible residue of the solution
used.
For letting water inside the mixers, use the button “mixer
wash”; if necessary, enable it from the menu (see para-
graph on the dispenser’s parameters)
Important!
The machine is equipped with an automatic wash-
ing system for the mixers with relative hydraulic
circuit and the infuser unit.
If the use of the machine is subject to idle periods (week-
ends, etc.), even for less than two days, it is good prac-
tice to enable the automatic washing functions (before
beginning to use the DA for example)
OPERATION
The following paragraphs describe the operation of the
main components of the machine.
CUP SENSOR
Some of the models are equipped with a cup sensor
which detects the presence of objects between the
reector and the sensor.
In order for the sensor to work correctly, the beamer and
the reector in front of it need to be kept clean.
6
5
3
1
2
4
Fig. 25
1- Dispensing unit tank
2- Grid
3- Cup sensor
4- Board
5- Glass cover for reflector
6- Unit lighting LED
DISPENSING UNIT LIGHTING
Some of the models are equipped with LEDs for the
dispensing unit lighting.
The LEDs switch on when the drink is being dispensed
and remain on for a few seconds after the end of the
dispensing.
BUTTON LEDS
The selections menu has LEDs.
During the heating or energy saving phases the LEDs
are o.
During normal operation, the LEDs are lit;
After asking a selection, the required selection button
ashes and the other buttons are not illuminated.