28 05 2013 4365 00
ENGINEER MENU
Below is an explanation of the main software functions
which manage the operation of the machine, grouped
by logic of use and not necessarily in the order in which
they are displayed in the menu.
The software version can be updated using the appropri-
ate systems (PC, UpKey, etc.)
For more information and details please refer to the
doses table supplied with the machine, taking into ac-
count the software version of the machine.
By pressing the key
from the “Loader” mode, the ma-
chine goes into “Engineer menu” mode.
The display shows the rst item of the “Engineer” menu
with the available operations.
The last row of the display contains the menu and the
number, which allow you to identify the current level.
- By pressing the confirmation key
you can access the
menu.
- By pressing the exit key
you go back to the previous
menu.
- The keys
and
allow you to navigate through the
items of the menu:
Notes:
If you want to go back to the Loader mode, press the key
from any rst level function.
PAYMENT SYSTEMS
You can decide which protocols to enable for the pay-
ment systems available and manage the relative func-
tions.
The communication protocols for the payment systems
available are as follows: Validators, Executive, BDV,
MDB.
Some parameters shared by several payment systems
keep the set point even if you change the type of system.
If necessary, they can be modied by the menus of the
various payment systems.
validator
immediate Change
The amount relative to a selection is generally cashed
after the machine has sent the “Successful selection”
signal.
If you enable this function, which is disabled by default,
the cash signal is sent at the start of the dispensing
cycle.
The setup of this parameter is compulsory.
deCimal point position
Press Enter key
to display the decimal point position,
i.e.:
0 decimal point disabled
1 XXX.X (one decimal digit after the point)
2 XX.XX (two decimal digits after the point)
3 X.XXX (three decimal digits after the point)
If you press Enter key
, these values ash on and o
and can be modied.
booking time
For cash payment, it enables the user to set up how long
the machine is intended to display the residual credit
necessary to dispense the selection (7 seconds by
default).
line / value assoCiation
When the display is positioned on the “LINE-VALUE AS-
SOC.” function (line programming) of the “programming”
menu, you can vary the value of the 6 coin lines of the
validator from A to F.
overpay
You can decide whether:
- to cash the credit exceeding the selection amount after
a well-dened time interval expressed in seconds (pa-
rameter “deleted 000”)
- to leave the credit exceeding the selection amount at
the user’s disposal for a subsequent selection (param-
eter “kept”)
To Next Page
Loading...
