EVOCA Opera - Page 35

29 05 2013 4365 00
exeCutive
Coin meChanism version
You have to choose among the following payment sys-
tems for the Executive system:
- Standard
- Price holding
- UKEY (Price holding price display)
immediate Change
The amount relative to a selection is generally cashed
after the machine has sent the “Successful selection”
signal.
If you enable this function, which is disabled by default,
the cash signal is sent at the start of the dispensing
cycle.
The setup of this parameter is compulsory.
booking time
For cash payment, it enables the user to set up how long
the machine is intended to display the residual credit
necessary to dispense the selection (7 seconds by
default).
bdv
The BDV protocol menus will enable the user to dene
the following functions.
immediate Change
The amount relative to a selection is generally cashed
after the machine has sent the “Successful selection”
signal.
If you enable this function, which is disabled by default,
the cash signal is sent at the start of the dispensing
cycle.
The setup of this parameter is compulsory.
booking time
For cash payment, it enables the user to set up how long
the machine is intended to display the residual credit
necessary to dispense the selection (7 seconds by
default).
type of dispensing CyCle
Used to set the operation mode by multiple or single
dispensing. In case of multiple dispensing, the change
is not automatically given at the end of a successful
delivery, but the credit will remain available for further
dispensing. If you press the coin return button, the
remaining credit will be returned if its value is lower than
the maximum change value.
Credit return (esCroW lever)
Used to enable/disable the credit return (by pressing the
change return key) if no dispensing has been performed.
If enabled, this function will provide for the return of the
coins even if the rst dispensing cycle has not occurred.
If a delivery has failed for any reason whatsoever, the
change will be paid upon request.
maximum Credit
Function used to dene the maximum accepted credit
for inserted coins.
maximum Change
You can set a limit on the total amount of the change
the coin mechanism will pay as soon as you press the
change button or after one single dispensing.
The credit exceeding the amount you have programmed
by this function will be cashed.
Coins aCCepted
Used to dene which coins shall be accepted among
those recognised by the validator.
For the coin/value correspondence check the label
showing the position of the coins on the coin mecha-
nism.
Change Coins aCCepted
Used to program the refusal of a coin in case of “exact
amount”.
For the coin/value correspondence check the label
showing the position of the coins on the coin mecha-
nism.