EVOCA Opera - Page 37

31 05 2013 4365 00
maximum Change
You can set a limit on the total amount of the change
the coin mechanism will pay as soon as you press the
change button or after one single dispensing.
The credit exceeding the amount you have programmed
by this function will be cashed.
Coins aCCepted
Used to dene which coins shall be accepted among
those recognised by the validator when the change
tubes are full.
For the coin/value correspondence check the coin
mechanism conguration.
Coins returned
Used to dene which coins shall be used to give the
change among those available in the tubes. This param-
eter is active only with the coin mechanisms not intend-
ed to manage the choice of the tube in use automatically
(Auto changer payout).
For the coin/value correspondence check the coin
mechanism conguration.
bills aCCepted
Used to dene which bills shall be accepted among
those recognised by the reader.
For the bill/value correspondence check the reader
conguration.
exaCt Change Coins aCCepted
Used to dene which coins shall be accepted among
those recognised by the validator when the machine is in
the “exact amount” mode.
For the coin/value correspondence check the coin
mechanism conguration
exaCt Change bills aCCepted
Used to dene which bills shall be accepted among
those recognised by the reader when the machine is in
the “exact amount” mode.
For the bill/value correspondence check the reader
conguration.
hide key Credit (Cashless private)
To protect the users’ privacy, this function is intended to
display the string “-----” in the place of the credit on the
cashless system.
residual Credit
You can decide whether to cash after a well-dened time
interval (deleted later) or leave the credit (kept) exceed-
ing the selection amount at the user’s disposal.
Cash-sale Control
Used to give evidence that cash transactions have oc-
curred by means of a cashless system.
The values available are listed here below:
- 0 standard operation: cash transactions are recorded
as such
- 1 forced sending to cashless 1: cash transactions are
recorded as transactions performed by the first cash-
less system
- 2 forced sending to cashless 2: cash transactions are
recorded as transactions performed by the second
cashless system
parallel maChine
Function used to enable the presence of a validator or
parallel bill reader to recharge the key.
exaCt Change equation
To choose among 15 dierent algorithms to enable the
machine to give the change at the end of the selection.
Every single algorithm checks a series of requirements,
such as the amount of coins in the tubes or the (empty
or full) state of the tubes the coin mechanism will use to
give the change.
If one of these requirements is not fullled, the machine
can supply no change. In this case, the display will show
the “No change” message
maximum Cashless key Credit
Function used to set up the maximum credit a cashless
key/card may have to be accepted by the system. If the
key has got a higher value, it will be rejected.
The setup value shall always be higher than or equal to
the value set for the “Maximum cash revalue” function.
If modied and lower, it will be automatically set to the
same value as the “Maximum cash revalue”.
maximum Cashless key reCharge
Used to set up the maximum credit you can charge on a
key or card system.
minimum tube level
Used to set a number of coins between 0 and 15 in order
to establish the status of full change tubes and to warn
the user to “insert the exact amount”.