Introducing the FIP-400B Fiber Inspection Probe and ConnectorMax2 Mobile
4 FIP-400B
Probe
The status LED gives you information about the probe or the analysis
results. See Probe LED Indicators on page 8 for details.
The battery LED indicates the charge status of the probe. See Probe
LED Indicators on page 8 for details.
The Wi-Fi LED gives you information about the transmission process.
See Probe LED Indicators on page 8 for details.
The interchangeable adapter tips give you the possibility to use various
tips depending on the type of connector you are inspecting.
See Changing the Fiber Inspection Probe Tip on page 27 for details.
Removable nozzles can be used with MF-Ready probes to inspect
multifiber dense panels. See Changing the FIP Nozzle (MF-Ready
Probes Only) on page 28 for details.
The micro-USB power adapter recharges the battery of the probe
when it is low. You can recharge the battery with the provided USB
cable and the power adapter that you connect to a power outlet. You
can also use the provided USB cable alone that you connect to a USB
port of a computer. See Recharging the Battery on page 113 for details.
When the probe is connected to a power outlet or to a USB port, it still
works via Wi-Fi.
The battery compartment door is for battery replacement.
See Replacing the Battery on page 115 for details.
The trigger allows you to inspect single-row or dual-row multifiber
connectors.
The design of the inspection tip enables you to connect any of the
interchangeable nozzles.
The probe comes equipped with a protective cap that fits over basic tips;
therefore, you do not need to remove the tip before putting the cap on.
To Next Page
Loading...
