Troubleshooting
Fiber Inspection Scope 95
Solving Common Problems
On my unit, no wireless
network is displayed.
No network has been
configured yet.
You must first configure the desired
networks on your smart device,
using in the EXFO Exchange
application (see Working With a
Wireless Network on page 62).
My unit does not
connect automatically to
the wireless network
that I have used during
my last work session.
There is a connection
problem with the
network.
Ensure that the Wi-Fi
connection is enabled on your
unit (see Enabling or Disabling
the Wireless Communication
on page 59).
In the case of a secured
network, ensure that the
password has not changed
since the initial configuration of
this network. If the password is
no longer valid, you will have to
update it using the EXFO
Exchange application
(see Working With a Wireless
Network on page 62).
Ensure that the network is
working normally and that your
unit is within the network’s
range.
If the problem persists, restart
your unit to force a new
connection to the network.
Problem Possible Cause Solution
To Next Page
Loading...
