Pilot’s Operating Handbook Section 4
EXTRA 500 Normal Procedures
4.7.b Interior Check
Entrance Door; Re-check closed and secured
After entering and taking seat position, the following cabin
procedures are to be carried out:
Seat Belts and Shoulder Harness; Adjust and locked
Passengers; Seated and strapped
Flight Controls; Check free movement
Note BUS TIE circuit breaker must be out!
Push in the
BUS TIE circuit breaker only in case of a generator
failure and if access to the load bus is necessary.
Circuit Breakers (others); Re-check in
BATT; ON
Stall Warning System; Check function
To avoid leaving the powered aircraft, the following items
should be performed with an assisting person outside the
aircraft.
The assisting person shall actuate the stall warning (lift
detector) switch carefully by hand. Thus to check function of
the system as red STALL WARN light on annunciator panel and
stall warning horn.
L – PITOT – R; (max. 10 seconds) – TEST –
The assisting person shall carefully touch the left and right wing
pitot head and left wing lift detector. This units should become
warm. Warning and advisory lights should not illuminate when
systems are tested.
26. January 2011
4-31
To Next Page
Loading...
