Extreme Networks Summit X460 Series - Summit X460 Series Switch Leds

Summit X460 Series Switches
Summit Family Switches Hardware Installation Guide
115
Summit X460 Series Switch LEDs
Table 33 describes the LEDs on the Summit X460 series switches.
Table 31: LEDs on the Summit X460 Series Switches
Label or Type Color/State Meaning
Front Panel LEDs
MGMT Steady green Power-on self test (POST) completed successfully;
normal operation.
Blinking green POST is in progress.
Blinking amber POST failed, or the system has over-heated.
Off No external power attached.
FAN Steady green Normal operation.
Blinking amber Failure.
Off No power.
PSU-1, PSU-2 Steady green Normal operation.
Steady amber Power is attached, but no power is on.
Blinking amber Failure.
Off No power is attached.
10G 1 – 2 Steady green Link OK on the indicated 10-Gbps port.
Blinking green Activity on the indicated 10-Gbps port.
Stack Management 1 – 2 Steady green Link OK on the indicated stack port.
Blinking green Activity on the indicated stack port.
2-digit Stack number Indicator
Left digit (1) Reserved for future use
Right digit (1 – 8)
Indicates the position of this
switch in the SummitStack
configuration.
Upper half blinking This switch is the stack master node.
Lower half blinking This switch is the stack backup node.
Lit steadily This switch is a standby node in the stack.
Ethernet Ports
1 – 28 or 1 – 48
Steady green Link OK
Blinking green Activity
Off No link, or port is disabled.
Additional Port LED meanings for PoE switches: Summit X460-24p & Summit X460-48p
All front-panel ports Steady amber Port is powered with link, no traffic
Blinking amber Port is powered with link, traffic
Off Port is not powered, has no link, or is disabled
Management Port Steady green Link OK
Blinking green Activity
Off No link, or port is disabled.
Back Panel
Port LED
(on installed port option card)
Steady green Link OK
Blinking green Activity
Stacking Port LED
(on installed SummitStack or
SummitStack-V80 module)
Steady green Link OK
Blinking green Activity